setup of ISDN cards failed

  • Hi everybody again,


    as described I installed the home edition of starface for evaluation successfuly, but now I have some issues to really get it running.


    The test PC I used, has 3 ISDN cards, two Fritz cards and one Diva card. The two Fritz cards are recognized, the Diva is not. So far so good, as this is consistent with the list of supported HW of Starface.


    Now I seem to have a problem configuring the two Fritz cards. Here is what I did:


    a) I added a single new line and called it "ISDN"
    b) Then I added boith Fritz cards to this line, because I have several ISDN lines from my provider, which use a pilot line and were handled by our previous PBX
    c) I marked both ISDN cards as active
    d) I provided a number ares for this line, secifying a m,ulti device connection and ourt former number block.


    Unfortunately the two cards stay dark grey, where I expected them to either turn green (for ok) or red (for not ok).


    So hwatr is missing?


    Can anytbody help me?


    Regards


    Markus

Jetzt mitmachen!

Sie haben noch kein Benutzerkonto auf unserer Seite? Registrieren Sie sich kostenlos und nehmen Sie an unserer Community teil!